User Instructions

UM581127000

Spec. No. 581127000 (Model 710NPBA)

Issue AB, March 22, 2012

 

 

Replacing a Distribution Device

General

Replace distribution devices with the same type and rating. Refer to System Application Guide SAG581127000 for part numbers.

Distribution Fuse “Alarm Fuse” Replacement

If a distribution fuse opens, the associated alarm fuse opens. Replace the distribution fuse before replacing the alarm fuse.

Procedure

1)An alarm fuse is removed by pulling it straight out of the fuseholder. If the alarm fuse is located in a modular fuse carrier, hold the fuse carrier in place with your thumb while pulling on the alarm fuse to prevent the entire carrier from inadvertently being pulled out.

2)Safety fuse covers are provided for all Bussmann GMT type fuses installed in the system. These covers snap onto the fuses and provide protection from exposed electrical terminations when a fuse opens. Insure that the safety fuse cover is installed after replacing a fuse. Refer to Figure 4-1for installation details.

Safety Cover

Safety Cover

P/N 248898700

P/N 102774

(GMT-X)

(GMT-Y)

Figure 4-1

Installation of Safety Fuse Covers

Chapter 4. Troubleshooting and Repair

Page 19

This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy

Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.

Page 25
Image 25
Emerson 710NPBA manual Replacing a Distribution Device, General, Distribution Fuse Alarm Fuse Replacement