The
The 2G4072-52
This section provides an overview of the Enterasys Matrix N SA 2G4072‐52. For information about software features of the 2G4072‐52 and how to configure them, refer to the Enterasys Matrix N Standalone Series Configuration Guide.
2G4072-52
The Enterasys Matrix N SA 2G4072‐52 has 48, 10/100/1000BASE‐T/‐TX compliant ports, through fixed front panel RJ45 connectors and 4 Mini‐GBIC ports, as shown in Figure 1‐1. Each of the fixed front panel ports can operate in either half‐duplex or full‐duplex mode which can be determined by either auto‐negotiation or manual configuration.
Enterasys Matrix N SA 2G4072‐52 ports can be configured to control traffic by limiting its rate and prioritizing it to expedite higher priority flows through the device.
Figure 1-1 2G4072-52 Front Panel
RESET 
CPU
CONSOLE PWR
GROUP 3
GROUP | 1 | 2 | 3 | 4 |
SELECT | ||||
GROUP 2 |
|
|
|
|
GROUP 1 |
|
|
|
|
5 | 6 | 7 | 8 |
9 | 10 | 11 | 12 |
13 | 14 | 15 | 16 |
17 | 18 | 19 | 20 |
Connectivity
Depending on how the 2G4072‐52 is configured, it can support up to 48, 10BASE‐T/ 100BASE‐TX switched ports connected through the front panel connectors.
Management
Management of the device can be either in‐band or out‐of‐band. In‐band remote management is possible using Telnet, Enterasys Networks’ NetSight® management application, or WebView™ application. Out‐of‐band management is provided through the RJ45 COM (Communication) port on the front panel using a VT100 terminal or a VT100 terminal emulator.
Switch Configuration Using WebView
Enterasys Networks’ HTTP‐based Web management application (WebView) is an intuitive web tool for simple management tasks.
