Connecting Power

Connecting Power

To connect the module to the power sources, refer to Figure 3‐3 and proceed as follows.

Note: The two power supplies in the module have automatic voltage sensing that allows connection to power sources ranging from 100–125 Vac, 2.5 A or 200–240 Vac, 1.25 A, 50/60 Hz.

To connect the module to the power sources, refer to Figure 3‐3 and proceed as follows:

1.Plug a power cord into each switch AC power receptacle. To take advantage of redundancy capabilities, plug each power cord into a separate dedicated AC outlet.

2.Plug the cord into a dedicated grounded AC outlet as shown in Figure 3‐3.

Figure 3-3 Connecting Power

Á

Á

AC INLET 1

AC INLET 2

100 - 125V ~ 3.6A

100 - 125V ~ 1.8A

200 - 240V ~ 1.6A

200 - 240V ~ 0.8A

50/60 Hz

50/60 Hz

Â

1AC power cords

À

2AC power outlets

Â

À

3AC power receptacles

3.Observe the LANVIEW LEDs. The Power (PWR) LED (not shown), located on the front panel, turns ON (green) and the CPU turns red until the module completes its initialization. It takes under 30 seconds for the module to boot up.

Note: If the power-up sequence is interrupted on this device, or if optional hardware has been installed or removed, this device may run an extended diagnostics sequence that may take up to two minutes to complete.

If the initialization process is successful, the CPU LED turns green. If the CPU LED does not turn green, refer to Chapter 4 for troubleshooting information.

3-4 Installation

Page 30
Image 30
Enterasys Networks 2G4072-52 manual Connecting Power