Memory Locations and Replacement Procedures

3.Push the connector arms away from the memory module to release the DRAM SIMM from the connector, as shown in Figure B‐6.

Note: The ejector arms on this connector are not spring loaded, so they will remain in the open position until manually closed.

Figure B-6 DRAM SIMM Connector Location

Á

À

Â

À

1 Connector arms

2 DRAM SIMM

3 Connector contacts

Installing the DRAM SIMM

To install the memory module, refer to Figure B‐7 and proceed as follows:

1.Push the connector arms away from the DRAM SIMM far enough to insert the DRAM SIMM into the connector contacts.

2.Insert the DRAM SIMM straight down between the connector contacts far enough for the tabs on the connector arms to align with the two DRAM SIMM alignment notches.

3.Push the DRAM SIMM down into the connector contacts. Then rotate the two connector arms toward the DRAM SIMM to lock it into place.

B-8 Mode Switch Bank Settings and Optional Installations

Page 66
Image 66
Enterasys Networks 2G4072-52 manual Installing the Dram Simm, Figure B-6 Dram Simm Connector Location