IP Configuration
Use the IP Configuration screen to set the bootup option, or configure the switch’s IP parameters. The screen shown below is described in the following table.
Vertical Horizon Local Management
Network Configuration: IP Configuration
Interface Type | : Ethernet |
IP Address | : 10.1.0.1 |
Subnet Mask | : 255.255.0.0 |
Gateway IP | : 10.1.0.254 |
IP State | : |
Use <TAB> or arrow keys to move, other keys to make changes.
Figure 2-8. IP Configuration
Parameter | Default | Description |
Interface Type | Ethernet | Indicates IP over Ethernet. |
IP Address | 10.1.0.1 | IP address of the stack you are managing when |
|
| accessing the agent module over the network. |
|
| The agent module supports SNMP over UDP/IP |
|
| transport protocol. In this environment, all |
|
| systems on the Internet, such as network |
|
| interconnection devices and any PC accessing |
|
| the agent module (or running management |
|
| software) must have an IP address. |
|
| Valid IP addresses consist of four numbers, of 0 |
|
| to 255, and separated by periods. Anything |
|
| outside of this format will not be accepted by the |
|
| configuration program. |
Subnet Mask | 255.255.0.0 | Subnet mask of the agent you have selected. This |
|
| mask identifies the host address bits used for |
|
| routing to specific subnets. |
Default Gateway | 0.0.0.0 | Gateway used to pass trap messages from the |
|
| switch’s agent to the management station. Note |
|
| that the gateway must be defined if the |
|
| management station is located in a different IP |
|
| segment. |
IP State | USER- | Specifies whether IP functionality is enabled via |
| CONFIG | manual configuration, or set by Boot Protocol |
|
| (BOOTP). Options include: |
|
| |
|
| based on the default or user |
|
| specified IP Configuration. |
|
| (This is the default setting.) |
16 |
