![](/images/new-backgrounds/1299875/299875167x1.webp)
Configuring Port Operation
You can configure switch ports for operational parameters such as auto- negotiation, duplex mode, port speed and flow control. The
Therefore, these two parameters, along with
To configure port operation, do the following:
1.Select Device Control Menu from the Main Menu.
2.Select Port Configuration and press [Enter].
3.Select the stack unit and port number to configure.
4.In the Admin column, select ENABLED. You can also disable the port due to abnormal behavior or for security reasons.
5.In the Flow Control column, select ENABLED to enable flow control or DISABLED to disable it. When enabled, the switch uses back pressure for half duplex and IEEE 802.3x for full duplex. These flow control methods can also be set directly by selecting BACK_PRESSURE or 802.3X. Note that flow control should not be used of the port is connected to a hub.
6.In the Speed and Duplex column, select AUTO to enable Auto- negotiation for the port, or select 1000_FULL, 1000_HALF, 100_FULL, 100_HALF, 10_FULL, or 10_HALF.
If
76 Configuring & Monitoring the Switch |