Configuring STA for Ports or Modules

The following figure and table describe STA configuration for ports or modules. (Note that the Spanning Tree Configuration screen for the expansion slots also indicates module type.)

Vertical Horizon Local Management -- VH-2402S

Fast forwarding mode of all ports : [Enable] [Disable]

Spanning Tree Port Configuration : Unit 1 Port 1-12

Port

Type Priority

Cost

FastForwarding

 

----------------------------------------------------

1

10/100TX

128

19

ENABLED

2

10/100TX

128

19

ENABLED

3

10/100TX

128

19

ENABLED

4

10/100TX

128

19

ENABLED

5

10/100TX

128

19

ENABLED

6

10/100TX

128

19

ENABLED

7

10/100TX

128

19

ENABLED

8

10/100TX

128

19

ENABLED

9

10/100TX

128

19

ENABLED

10

10/100TX

128

19

ENABLED

11

10/100TX

128

19

ENABLED

12

10/100TX

128

19

ENABLED

<APPLY> <OK> <CANCEL> <PREV UNIT> <NEXT UNIT> <PREV PAGE> <NEXT PAGE>

Use <TAB> or arrow keys to move, other keys to make changes.

Figure 2-24. Spanning Tree Port Configuration

Parameter

Default

Description

Fast forwarding mode

ENABLED

Allows you to enable or disable fast forwarding for

of all ports

 

all ports on the switch.

Type

 

Shows 10/100TX, 100FX, 1000LX or 1000SX port.

Priority

128

Defines the priority for the use of a port in the STA

 

 

algorithm. If the path cost for all ports on a switch

 

 

are the same, the port with the highest priority (i.e.,

 

 

lowest value) will be configured as an active link in

 

 

the spanning tree. Where more than one port is

 

 

assigned the highest priority, the port with lowest

 

 

numeric identifier will be enabled.

 

 

The range is 0 - 255.

(Path) Cost

100/19/4

This parameter is used by the STA algorithm to

 

 

determine the best path between devices.

 

 

Therefore, lower values should be assigned to

 

 

ports attached to faster media, and higher values

 

 

assigned to ports with slower media.

 

 

(Path cost takes precedence over port priority.)

 

 

The default and recommended range is:

 

 

Ethernet: 100 (50~600)

 

 

Fast Ethernet: 19 (10~60)

 

 

Gigabit Ethernet: 4 (3~10)

 

 

The full range is 1 - 65535.

9033645-01

VH-2402S User Interface 33

Page 41
Image 41
Enterasys Networks VH-2402S manual Configuring STA for Ports or Modules, Spanning Tree Port Configuration