Setting a Default Gateway
The default Gateway parameter defines the IP address of a router or other network device to which IP packets are to be sent if destined for a subnet outside of that which the switch is operating.
To set a default gateway, do the following:
1.Select Management Setup Menu from the Main Menu.
2.Select Network Configuration and then IP Configuration.
3.In the field Gateway IP,enter the IP address and press [Enter].
Configuring BootP
The BootP protocol allows you to automatically configure the switch’s IP address information. Enabling this feature greatly speeds up device configuration, especially when a large number of devices are installed.
A BootP server must be operating on the network and be properly configured for this option to work. When this option is enabled, the switch tries to obtain an IP address from the BootP server.
To configure BootP, do the following:
1.Select Management Setup Menu from the Main Menu.
2.Select Network Configuration and then IP Configuration.
3.In the IP State field, select
This selection toggles between
78 Configuring & Monitoring the Switch |
