Epson 410 manual Software DIP Switches and Eeprom Commands

Chapter 5 Printer Commands

))))))))))))))))))))))))))))))))))))))))))))

5.3.1SOFTWARE DIP SWITCHES AND EEPROM COMMANDS

The following commands are different from the other printer commands in that they are stored in EEPROM, are non-volatile and configure the machine upon power-up. Once sent to the printer, they do not need to be sent again.

The printer will only configure to the following commands after a the machine has been powered off and then turned back on. The printer will not accept these commands until this is done.

^A ^D COMMAND

20Change baud rate: Unless otherwise requested by the customer, the baud rate of the printer is 9600. (To change baud to 19200 use ^A8^D20<CR>)

0110 Baud

1150 Baud

2300 Baud

3600 Baud

41200 Baud

52400 Baud

64800 Baud

79600 Baud

819200 Baud

))))))))))))))))))))))))))))))))))))))))))))

410 Operators Manual 37