Epson 410 manual Command Auto-Size Label

Printer Commands			Chapter 5
))))))))))))))))))))))))))))))))))))))))))))
^A	^D	Command
	39	Auto-Size Label:
0		Clears the use of auto-size values set by ^A1^D39.
1		Uses the values obtained for the variables above instead of what the user
		supplies in the header of the file format. This will not display the variables on the
		screen.
2		Automatically sizes the label and displays on the screen the values for the size
		variables. These values should be placed in the label header for that stock.
3		Same as ^A2^D39, but prints the values on a label, instead of on the screen.
		(Note: The LCB should be set to 1 before auto-sizing black line stock.
		^A1^D47<CR>)

XX91 Load Value for Printer to See Valid Gap. Obtained from the auto-size (^D39) command. This value states the translucent properties of stock to the gap detector. This ^AXX^D91 command should be at the beginning of all format files if suggested ^D91 value returned from auto-size is not between 50 and 70 or the default value creates skipping over the label gap. Skipping over the label gap is defined as the printing of one label and then the printing of a blank label. This condition occurs because the default ^D91 value cannot adjust for stock that has unusual translucent properties (old stock, thick tag stock, unusual backing paper, etc.). This problem can be rectified by auto-sizing the stock.

))))))))))))))))))))))))))))))))))))))))))))

44 410 Operators Manual