Printer Commands | Chapter 5 |
))))))))))))))))))))))))))))))))))))))))))))
^A ^D COMMAND
23Change SW3: Software dip switch #3. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******. Not Used
******.Q Not Used
*****.)Q 1=Enable 460 Emulation, 0=Disable
****.))Q 1=Enable 450 Emulation, 0=Disable
***.)))Q 1=Enable Label Centering, 0=Disable **.))))Q 1=Send Response After a Print
**0=No Response After a Print
*.)))))Q Not Used
.))))))Q Not Used
Position:
1Always 0
2Always 0
3Response After Print: If enabled, an enquiry response will be sent back through the serial port after every print.
4Label Centering: The printer will center all label formats if this position is set to 1. Label centering creates an X offset for the older formats that were left justified. It will not center normal format fields on the label. It offsets a previously left justified label. Not recommended for new applications.
5450 Emulation: Only used if 450 format files are being sent to the printer.
6460 Emulation: Used if 460 format files are being sent to the printer.
7Always 0
8Always 0
))))))))))))))))))))))))))))))))))))))))))))
40 | 410 Operators Manual |
