Printer Commands

Chapter 5

))))))))))))))))))))))))))))))))))))))))))))

^A ^D Command

56End of Label Fields: Select RAM format label.

57Enter Label Format Mode: This tells the printer that information for a label is following

65Emulation control: This list of commands was designed for those users who were previously using an older Microcom Corporation printer and now want to use their old format files with the model 410 printer. Label centering creates an X offset for the older formats that were left justified. It will not center all the fields on the label. It offsets a previously left justified label. (Note: Not recommended for new formats.)

0

Disable All.

1

Enable Label Centering. Used only in conjunction with 450 and 460 emulation.

2

Enable 450 Emulation.

3

Enable 1 & 2.

4

Enable 460 Emulation.

5

Enable 1 & 4.

67Load Graphic Image: See chapter 6 for more details.

0

Send single graphic in four rotations.

1

Send graphic #1 of 2 in 2 rotations.

2

Send graphic #2 of 2 in 2 rotations.

93Load Control Code Recognition Status: Some mainframe, mini-computer, and special-purpose computers cannot send ASCII characters under 20 hex or send these numbers for reasons other than 410 operation (spooler initialization, etc). In order to maintain proper flow control, the 410 printer will ignore everything under 20 hex if so directed. There is also an EEPROM dip switch (see section 5.3) that will enable the printer to enter this mode upon power-up. (Note: if control code recognition is disabled, the printer will not process the 1Bhex (ESC) character and therefore will not be able to store data streams.)

0

Enable control code recognition.

1

Disable control code recognition.

))))))))))))))))))))))))))))))))))))))))))))

58

410 Operators Manual

Page 64
Image 64
Epson 410 manual Disable All, Enable 450 Emulation, Enable 1, Enable 460 Emulation, Send single graphic in four rotations