Note:

If the status sheet does not print, first make sure that the printer is on line. If it is on line but the status sheet still does not print, you will have to reset the printer by turning it off and back on.

R Caution:

After turning off the power, wait at least five seconds before turning it back on; otherwise you may damage the printer.

Report printing is available after the printer is turned on and has completed its initialization routine. The Status Sheet is not available when the printer has started printing or when the printer is off line or not ready.

Under normal operating conditions, the status sheet will print in one of the following emulation modes: ESC/P*-**, ESC/Page, PCL (LJ-2P, S/P/Si, LJ-4P), GL (HP-GL, HP-GL2, EP-GL), EpsonScript (PostScript), PR-201, GQ.

Using the EPSON PostScript card

If your printer has an EpsonScript (PostScript) card installed, allow a minute for the printer to initialize before trying to install or configure the Ethernet Card on the network. The Ethernet Card may not respond if initialization has not been completed.

Network installation

See the appropriate chapter in this guide for instructions on installing the card on a specific network.

1-6 Installing the Ethernet Card