EPSON Stylus Pro GS6000 User’s Guide

The Control Panel

Making the Custom Paper Type Setting

You can register up to 30 custom papers.

The registered number is displayed on the LCD panel when using the printer.

Note:

The printer becomes in the Ready state when you press the button at any point of making the following settings. The settings you have made so far are registered as the custom settings (including unchanged settings).

A Load the paper that you want to use.

Make sure to set the paper that is actually used.

B Enter the Paper Setup menu.

1.Press the button to enter the Menu mode.

2.Press the / button to display PAPER SETUP, and then press the button.

3.Press the / button to display PAPER SETUP once again, and then press the

button.

C Select the paper type.

You can select STANDARD or the number from 1 to 30.

1.Press the / button to select the paper type you want to register.

2.Press the button.

The settings you make from step 4 are registered in the number you have selected here.

If you select STANDARD, go to step 6.

Note:

❏We recommend you write down the registered number and the settings you make from step 4.

❏You can change the registered number on your computer by using EPSON LFP Remote Panel.

D Select a print mode.

1.Press the / button to select PRINT MODE, and then press the button.

2.Press the / button to select a suitable setting for the paper.

3.Press the button.

4.Press the button to go back to the previous menu.

E Set the paper feed adjustment, if necessary. See “Adjusting Paper Feed” on page 48

Note:

You can get a high-quality result if you print a sample image using EPSON LFP Remote Panel to set the value for Paper Feed Adjustment.

F Perform the head alignment, if necessary.

See “Aligning the print head using the control panel” on page 47

G Set the Pre Heater temperature.

1.Press the / button to select PRE HEATER, and then press the button.

2.Press the / button to select a preset temperature.

3.Press the button.

4.Press the button to go back to the previous menu.

H Set the Platen Heater temperature.

1.Press the / button to select PLATEN HEATER, and then press the button.

2.Press the / button to select a preset temperature.

3.Press the button.

4.Press the button to go back to the previous menu.

I Set the After Heater temperature.

1.Press the / button to select AFTER HEATER, and then press the button.

2.Press the / button to select a preset temperature.

3.Press the button.

4.Press the button to go back to the previous menu.

28