Printing

ProblemSolution

The number of lines printed does not match the length of the paper.

Regular gaps occur in the printout.

Skip over perforation is set, but the perforation does not fall in the center of the skip.

The page length may be set incorrectly. Change the page length setting with DIP switch 2-1. Refer to 3-9. If your program allows you to send control codes to the printer, specify page size by sending ESC C or ESC C 0. If this does not resolve the problem, check the page length set by your application software and adjust it if necessary.

If you are using the cut sheet feeder, the self test function prints the number of printable lines that can fit on a single sheet. Use this feature to determine the correct page length setting. Refer to 5-9.

One inch skip over perforation may be set. Set DIP switch 2-3 to OFF. If your program allows you to use control codes, use ESC 0 to cancel skip over perforation. Refer to 3-10.

The page length for continuous paper may be set incorrectly. Make sure the setting of DIP switch 2-1 matches your paper length. Refer to 3-9. If your program allows you to use control codes, you can also use ESC C or ESC C 0 command to set the page length. Refer to 9-13.

Troubleshooting 7-11