Options
ProblemSolution
Several lines of space occur in the printout.
Skip over perforation is set, but does not work.
Skip over perforation is set, but the skip has shifted from the perforation, or the perforation does not fall in the center of the skip.
The paper may have too much slack. Adjust the position of the sprockets to take up any slack along the width of the paper. Remove slack lengthwise by pressing in and rotating the pull tractor feed knob on the right. Refer to
The paper thickness lever may not be set correctly. Set the paper thickness lever to match the thickness of your paper. Refer to
The paper may not meet the specifications. Check that your paper is of the proper size, weight, and thickness. Refer to
You may have changed the DIP switches with the power on. To make new DIP switch settings effective, turn the power off, then on again.
The page length for one page of the continuous paper may be set incorrectly. Set DIP switch
The loading position of the paper may be too high or too low. Use the micro- adjustment feature to reset the loading position. Refer to
Troubleshooting