Maintaining and Transporting the Printer 137

5. Press to save the setting.

Using Maintenance Mode

Maintenance mode allows you to make special settings and perform maintenance procedures that may be needed occasionally. You can use maintenance mode to do the following:

•Change the language or units of measurements used on the printer’s control panel menus

•Change the default pressure setting for the automatic cutter

•Run a “super strong” cleaning cycle

•Enable power on roll paper feed

•Return all of the printer’s control panel settings to their default values

Follow these steps to use maintenance mode:

1.Make sure the printer is turned off.

2.Press and hold the Pause button, then press the P Power button and hold it until the printer turns on and displays MAINTENANCE.

3.Use the d and u buttons to select the settings described below. If you need to back up to the previous menu level, press l.

•To change the language on the LCD display, press d to select LANGUAGE, then press r. Press d until you see the language you want, then press to select it. The printer exits maintenance mode and returns to normal operation.

•To change the units of measurement, press d to select UNIT, then press r. Press d to switch from METER to FEET/INCH, then press to select it.

•To change the default cutting pressure, press d to select CUT PRESSURE, then press r to display 100%. Press d to decrease the pressure, or the u button to increase it (in 1% increments). Press to select the setting you want.