74 Handling Paper and Other Media

Note: If you notice head strikes on your prints, make sure your paper is flat. If so, try changing the platen gap setting to WIDE. If that doesn’t solve the problem, try changing it to WIDER.

Caution: To avoid damaging the printer, make sure you do not select the Narrow setting when you print on thick media.

Adjusting the Platen Gap for Thick or Thin Paper

When you print on unusually thick or thin paper, you may need to adjust the platen gap setting. STANDARD is the default setting. However, if print quality is not satisfactory when using very thin or very thick stock, you may need to change this setting.

1.Press r Menu.

2.Press r again to select the Printer Setup menu and highlight PLATEN GAP.

3.Press r again. STANDARD is highlighted as the current setting.

4.Use the u and d buttons to change the setting. (STANDARD is the default setting; you can also choose NARROW, WIDE, WIDER, or

WIDEST.)

5.Press the button to save the setting. An asterisk appears next to the selected setting.

6.Press the Pause button to exit the menu mode.

If you’ve selected a non-standard platen gap, the following symbols appear in the corner of the display to remind you of the narrow or wide setting:

Widest

Wider

Wide

Narrow

When you switch media, don’t forget to change the setting back to

STANDARD.

If you’re printing on non-Epson media and not using the Epson driver, you may also need to create a paper configuration to optimize your results. See page 75 for more information.