Exatron 3000B
www.exatron.com 5-13 Chapter 5 Diagnostics
;
;;
; INTERFACE CHECK: Input Sort Check__________________________________________________________________
This diagnostic tests port 14, located on PCB #5000-A89, PAL A89-2.
TO ENTER THIS CHECK:
Handler displays DIAGNOSTICS
Press the [3] key.
Handler displays INTERFACE CHECK
Press the [3] key again.
Handler displays SORT INPUT CHK
Plug the EXATRON LED Checker into the handler's control port. Slide each of the LED checker's eight
position DIP switch micro switches. As you do, the corresponding red output cover LED will turn on.
These "input" signals should be latched and saved by the handler. Anytime you wish to reset the interface
latch, turn off all of the DIP switches, and then press the handler controller's [1] key.
Output Cover Handler Interface (24 pin "D" Connector)
LED Input Pin
1 1 (Sort 1)
2 2 (Sort 2)
3 3 (Sort 3)
4 4 (Sort 4)
5 5 (Sort 5)
6 6 (Sort 6)
7 7 (Sort 7)
8 8 (Sort 8)
FYI: 13 EOT (Special order only.)
Pressing the [Clear] button will flash the controller's displayed message to confirm that the handler is still
in this specific diagnostic check.
Press the [Enter] button to EXIT this diagnostic check.