Extron electronic 3200s manual Quick Recall Preset Rpr

QUICK RECALL OF
GLOBAL PRESETS COMMANDS	ASCII (HOST-SWITCHER)	RESPONSE (SWITCHER-HOST)
Quick Recall Preset	.	Rpr
Notes:

1.If the Quick Recall Preset ( .) command is issued without an active write, then error E10 occurs.

2.Complete backplane switch within 60mSeconds (apprx.) after receipt of the command.

3.Recall must take place 100mSeconds after End Write Mode command ( p).

4.Quick recall command only recalls last entered direct write preset.

SET NAMES COMMANDS	ASCII (HOST-SWITCHER)			RESPONSE (SWITCHER-HOST)
Read Global preset name		NG
Write Global preset name		nG	,	NamP
Read Room preset name		NP	*
Write Room preset name		nP	* ,	NamP
Read Room Name		NR
Write Room Name		nR	,	NamR
Read Virtual Input Name		NI
Write Virtual Input Name		nI	,	NamI
Read Virtual Output Name		NO
Write Virtual Output Name		nO	,	NamO
ADVANCED INSTRUCTION SET AND SIMPLE INSTRUCTION SET COMMANDS (PAGE 3 OF 3)
ZAP CONFIGURATION COMMANDS	ASCII (HOST-SWITCHER)			RESPONSE (SWITCHER-HOST)
Zap All Global presets & names		zG		ZapG
Zap individual Global		zT		ZapT
Zap All Room presets & names		zP		ZapP
Zap individual Room Preset		zT	*	ZapT
Zap All RGB Delay to Ø sec.		zD		ZapD
Zap all Audio Gains to Ø dB.		zA		ZapA
UnMute RGB/Audio (All Mutes)		zZ		ZapZ
Master Reset		zXXX		ZapXXX

ERROR CODES

If the switcher receives a command that is invalid or contains invalid parameters, it will return an Error Code response. The error code response has the format “Exx”. Following is a list of possible error code responses.

	Description of Error code
EØ1	Invalid input channel number (too large)
EØ5	Device is off
E1Ø	Invalid command
E11	Invalid preset number (too large)
E12	Invalid output number (too large)
E13	Value too large (Gain)
E14	Command not available for matrix configuration
E2Ø	Invalid BME number
E21	Invalid Room number
E22	Busy
E23	Checksum error

Matrix 3200/6400 Series • Programmer’s Guide 4-9