change the gain for output 51, pull the card for outputs 49-56, count from the top header pair which is for output 49. The target headers are H13 and H14; swapping their jumper positions will change the gain for output 51.

Gain jumpers must be changed in pairs (H9 & H10 through H23 & H24).

Do NOT change the position of the jumpers on headers 25 and 26 (H25 &

H26).

Adding BME(s) to a Matrix 3200/6400 System

Adding BME(s) to an existing Matrix 3200/6400 System involves doing most of the same steps as an initial installation. Extron recommends that the following steps be done in the order listed to add an Audio BME to an existing system.

1.See Page 5-12 “Software Procedure - Before and After a Hardware Upgrade”. Do steps under “Before Hardware Changes” before making any hardware changes.

To ignore step 1 and proceed with the hardware upgrade will require considerable system reconfiguration time. It is highly recommended that you not skip any step.

2.Remove power before proceeding. Go to “Adding a Matrix 6400 Audio BME” (see Page 5-10 below). If this is not an Audio BME add-on, go to Chapter 2.

3.Set the BME address numbers (0 - 5). (Page 2-3)

4.Connect the BME COMM interconnecting cable(s). (Page 2-3)

5.Connect the RS-232/RS-422 cable to the serial port of BME #0. (Page 2-3)

6.Connect the AC Power cable(s) to the BME(s). (Page 2-3)

7.Apply AC power to the BMEs and Verify Normal Power-Up. (Page 2-3)

8.Do the steps under “After Hardware Changes” on Page 5-13.

9.Connect cables to BMEs (video, sync and/or audio cables). (Page 2-5)

The procedure for adding an Audio BME follows.

Adding a Matrix 6400 Audio BME

The Matrix 6400 Audio BME may be installed in a rack with an existing Matrix 3200/6400 system, or it may be installed in a different location. BMEs may be separated by up to 12 feet and rack mounting is NOT required. If the Audio BME is going to be rack mounted with other BMEs, they may be mounted in any order within a rack or

FPC-1000

MATRIX 6400

AUDIO

MATRIX 6400

WIDEBAND VIDEO

MATRIX 6400

WIDEBAND VIDEO

MATRIX 6400

WIDEBAND VIDEO

MATRIX 6400

SYNC

MATRIX 6400

SYNC

Figure 5-10.A

Matrix 3200/6400 Series • Upgrades and Troubleshooting 5-11

Page 53
Image 53
Extron electronic 3200s manual Adding BMEs to a Matrix 3200/6400 System, Adding a Matrix 6400 Audio BME