Extron electronic MVX 128 manual Performing a hard reset from the rear panel

Performing a hard reset from the rear panel

The hard reset function restores the switcher to the original factory default settings. All user files and settings are maintained. Perform a hard reset as follows:

1.	If necessary, turn off power to the switcher.
2.	Press and hold the Reset button on the rear panel while you apply AC power
	to the switcher (figure 3-58).

Press and hold the Reset button while you apply power to the switcher.

RESET

The switcher flashes the LEDs and then turns them off.

Power

Continue to hold the Reset button until all input and output LEDs return to unlit and the RGBHV or Video and Audio LEDs turn on.

RESET Release the Reset button.

Figure 3-58 — Hard reset

NA hard reset returns the switcher to the default (factory) firmware configuration. The switcher continues to operate using this firmware until you either cycle power, in which case the switcher begins to use the most-recently installed firmware update, or install a new firmware update.

Optimizing the Audio

Each individual input audio level can be adjusted within a range of -18 dB to

+24 dB, so there are no noticeable volume differences between sources and for the best headroom and signal-to-noise ratio. Adjust the audio gain and attenuation as follows:

1.	Connect audio sources to all desired inputs and connect the audio outputs
	to output devices such as audio players. See Audio connections, in chapter 2,
	Installation. For best results, wire all of the inputs and the outputs as balanced.
2.	Power on the audio sources, the switcher, and the audio players.
3.	Switch among the inputs (see Creating a configuration, on page 3-8), listening
	to the audio with a critical ear or measuring the output audio level with test
	equipment, such as a VU meter.
4.	As necessary, adjust the input audio level of each input (see Viewing and
	adjusting the input audio level, on page 3-24) so that the approximate output
	level is the same for all selected inputs.
5.	As necessary, adjust the output audio level of each input (see Viewing and
	adjusting the output volume, on page 3-28).

MVX 128 A VGA Matrix Switchers • Operation 3-35