Extron electronic SGS 408 Setting up the Square wipe effect, Implementing an established effect

Operation, cont’d

	8 X X X . X X K H z X X . X X H z			H W i p e
	4 X X X . X X K H z X X . X X H z			L t t o R t
	1 2 8 0 X 1 0 2 4 @ 6 0 H z			S q u a r e
	Tr u e ( D V I ) o n l y			3 . 4 S e c o n d s
		I n	O u t	E s c
		Select a transition			Select duration
						Select effect
Figure 3-44 — Setting up the Square wipe effect
	8 X X X . X X K H z X X . X X H z			H W i p e
	4 X X X . X X K H z X X . X X H z			L t t o R t
	1 2 8 0 X 1 0 2 4 @ 6 0 H z			T i t l e
	Tr u e ( D V I ) o n l y			3 . 4 S e c o n d s
	W i n d o w		K e y	E s c
		Select a transition			Select duration
						Select effect

Figure 3-45 — Setting up the Title effect

3.To select a duration, turn the left adjustment knob until the desired duration appears. The duration ranges from 0.2 seconds to 5.0 seconds in 0.1 second increments.

Up to this point, you can cancel an effect by pressing the Esc button.

4.To select a transition, press its button (see “Available effects” on page 3-16). The default screen appears.

The dissolve and title effects have no transitions to select. To accept the effect, press the Take button.

Implementing an established effect

To implement an effect that has been set up (other than a title — see “Implementing a title” on the next page), do the following:

1.Press the preview input button to display the preview image on the preview monitor.

2.Press the Effect button for the desired effect. (If the button is already lit, you do not need to press it.)

3.Verify that the selected effect and its transition, as displayed in the top right of the default screen, are correct.

4.If desired, override the duration by turning the left adjustment knob.

5.When you want the effect to occur, press the Take button. The Take button lights, the effect occurs during the time specified by the duration, and the Take button light turns off.

3-22 SGS 408 Switcher • Operation