|
|
|
|
| Index Marker marks |
|
|
| ||
|
|
|
|
| Position 1 |
|
|
|
|
|
|
|
|
|
|
|
| 3 | 2 | 1 |
|
| 3 | 2 | 1 |
|
|
| 6 | 5 | 4 |
|
| 6 | 5 | 4 |
|
|
| 9 | 8 | 7 |
|
6L | 5L | 4L | 3L 2L | 1L | 6 | 5 | 4R | 3R | 2 | 1R |
|
|
|
|
| R | R |
|
| R |
|
Full vat element wire routing
Pull the element wires through the bushings on either side of the frypot and down the back. Element wires should be routed to the right of the ATO temperature probe on the back wall of the frypot.
Dual vat element wire routing
Pull the element wires through the bushings on either side of the frypot and down the back. Element wires should be routed to the center of the frypot between the ATO temperature probes.
Element grounding and wire routing
To ground the element wires, use the hole in the frypot frame located under the bushing that the element wires pass through. Using a screw through the ground wires ring terminal, connect it to the frypot using the probe ground clip. Use a tie wrap to tie up half of the element wires after the wires are pulled through the bushing. Do not pull tie wrap tight, leave it slack at about one inch
