Operation and Maintenance
The procedures for setting Setup mode are as follows.
(1)Turn the power ON by pressing “I” side of the power switch (see Figure 1.1). Then the scanner displays “Scanner Ready”
Scanner Ready | > |
(2)Press “Next” button. Then the scanner displays “Mode select 1”,
Mode select 1
M Manual mode change?
(3)Press “Next” button again. Then the scanner displays “Mode select 2”
Mode select 2
!Setup mode Change?
(4)Press “Enter” button. Now the scanner is in Setup mode.
(5)At first the screen is S41 in the screen flow chart next page. Select items by pressing “Next” or “Previous” buttons, and select parameters by pressing “ç” or “è” buttons, and press “Enter” button to set the parameter. Finally close the Setup mode by pressing “Exit” button. The flow chart of the Setup mode is in Figure 5.2