Fujitsu MB91460 SERIES, MB88121 SERIES FlexRay CC Operating-Mode S2, FlexRay CC Operating Mode

SK-91F467-FLEXRAY V1.1

Jumpers and Switches

3.2FlexRay CC Operating-Mode (S2)

The DIP-switch S2 is used to set the operating mode of the FlexRay communication controller. Ensure that the mode pin settings correspond to the operation-mode of the application. For more detailed information please check the Hardware-Manual of the FlexRay CC.

DIP switch		Setting	Logical value
S2/1 (MD0)		ON (closed)	0 (low)
		OFF (open)	1 (high)
S2/2 (MD1)		ON (closed)	0 (low)
		OFF (open)	1 (high)
S2/3 (MD2)		ON (closed)	0 (low)
		OFF (open)	1 (high)
			0 (low)
S2/4 (MDE0)		ON (closed)
		OFF (open)	1 (high)
S2/5 (MDE1)		ON (closed)	0 (low)
		OFF (open)	1 (high)
S2/6 (MDE2)		ON (closed)	0 (low)
		OFF (open)	1 (high)
Default:
	grey

Table 3-2: FlexRay CC Operating Mode

By default, the “16-bit non multiplexed mode” is selected.

	MD0 MD1 MD2	MDE0 MDE1 MDE2
Dip-Switch S2			ON
(default setting)			OFF

1 2 3 4 5 6

Figure 3-2: FlexRay CC Mode Switch

Note:

The DIP-switch (S2) on PCB rotated 180°

FMEMCU-UG-910017-11 - 20 - © Fujitsu Microelectronics Europe GmbH