Fujitsu MB91460 SERIES manual Checklist for project configuration, 0x0080.0000 0x009F.FFFF

SK-91F467-FLEXRAY V1.1

Getting Started

Always check the Linker Settings (“Project – Setup Project – Linker – Disposition”) to make sure the following memory map is applied according to the project configuration:

Recommended linker settings for “SK-91F467-xxx” starter kits for debugging

Memory Type	Used for		Area(s)	Sections
Data RAM,	Variables, Stack		0x029000 -	DATA, INIT, STACK
			0x02FFFF
External SRAM 1MB	Code,	Const,	0x00840000 -	CODE, CONST
	IRQ	Vector	0x0094FFFF
	Table

Table 5-2: Linker Settings for MB91F467DA Monitor Debugger configuration

Note:

In any case all settings must be checked and corrected corresponding to specific application requirements. Also check settings in the start91467.asm initialisation file! Use the linker mapping list (e.g. *.mp1 file) to check the final memory allocation.

The following chip select areas are used by the Softune monitor debugger and must not be used or overlap with other chip select areas:

CS1 – SRAM 0x0080.0000 - 0x009F.FFFF

Checklist for project configuration:

•Make sure, the correct Target MCU (“Project – Setup Project - MCU” menu) MB91F467D is selected.

•Use the correct linker settings as outlined above depending on your target MCU and the target area (embedded flash or external RAM).

•Use the provided templates to make sure the sections are located correctly.

•Always check the *.mp1 file (use right mouse click on top *.abs file in the project window of Softune Workbench and select “open list file”) to see the used sections and address areas!

•The following Chip select areas are used by the Softune monitor debugger and must not be used or overlap with other chip select areas:

CS1 – SRAM 0x0080.0000 - 0x009F.FFFF

Note:

Be aware that the Softune Workbench monitor debugger is only able to debug code which is located in RAM! It is not possible to debug code located in Flash memory!

FMEMCU-UG-910017-11 - 60 - © Fujitsu Microelectronics Europe GmbH