5.4 Command Protocol

5.4 Command Protocol

The host should confirm that the BSY bit of the Shadow Block Status register of the device is 0 prior to issue a command. If BSY bit is 1, the host should wait for issuing a command until BSY bit is cleared to 0.

Commands can be executed only when the DRDY bit of the Status register is 1. However, the following commands can be executed even if DRDY bit is 0.

EXECUTE DEVICE DIAGNOSTIC

INITIALIZE DEVICE PARAMETERS

5.4.1Non-data command protocol

Execution of the following commands does not involve data transfer between the host and the device.

RECALIBRATE

SEEK

READ VERIFY SECTOR(S) (EXT)

EXECUTE DEVICE DIAGNOSTIC

INITIALIZE DEVICE PARAMETERS

SET FEATURES

SET MULTIPLE MODE

SET MAX ADDRESS (EXT)

READ NATIVE MAX ADDRESS (EXT)

IDLE

IDLE IMMEDIATE

STANDBY

STANDBY IMMEDIATE

CHECK POWER MODE

SMART DISABLE OPERATION

SMART ENABLE/DISABLE AUTOSAVE

SMART ENABLE OPERATION

C141-E203-01EN

5-141

Page 215
Image 215
Fujitsu MHT2080BH Command Protocol, Non-data command protocol, Execute Device Diagnostic Initialize Device Parameters