Furuno FR-2135S manual RP Board RP-26, Table top/console type

4.3 RP Board RP-26

The RP Board RP-26, which providesvideo plotter functions, consists of a circuit board and a card drive both of which are accommodated in the display unit of the FR-2105 series radar.

Table top/console type

Necessary Parts: RP-26-T-2E (008-485-520)

Name	Type	Qty	Code no.
RP board	14P0298	1	008-487-640
Card case assy.	–	1	–
Panhead screw B	M4x8 C2700W	4	000-881-445
Panhead screw B	M3x8 C2700W	2	000-881-404
Panhead screw A	M2.6x5 C2700W	2	000-800-973
Teethed lock washer	M4 C5191W	1	000-864-506
(Outside teeth)
Cable assy.	HIF6-100D-A-A-52	1	000-137-553

1.Lift the monitor and fix it with the stay. Refer to Chapter 1 for instructions.

2.Remove the right arm cover from the control head.

3.Fasten the card case to the right arm cover as follows:

a)Fasten the ground wire with an M4x10 screw and washer (supplied) as shown below.

b)Fasten the arm cover to the card case with three M4x8 screws (supplied).

Card case

Figure 4-9 Fastening the card case to the right arm cover

4-10