Connection of display unit to control head
1.Attach the handle to the handle plate, using the screws for the handle and bottom cover of the control head.
2.Attach the handle plate to location where the KB arms were fastened.
3.Pull the monitor toward you until you hear click.
4.Lead in the cable assy. (option) from the rear entrance of the display unit. See Chapter 2.
5.Raise the monitor and fix the stay.
6.Inside the display unit, fasten ground wire of the cable assembly with an M4 screw on the chassis.
7.Plug in two connectors of connection cable (P412, J583: See illustration on the previous page.)
8.Lower the monitor.
9.Attach the monitor front cover (option) to the place the panel cover have been, using the screw for the panel cover.
10.Attach rubber to feet to the bottom of the keyboard if the keyboard is not going to be permanently fixed. To fix the keyboard to a desired location, fasten the KB fixing plate to the keyboard and desired location with two upset screws (M5X25, formerly used to fasten KB arms) and two tapping screws (φ 6.5, local supply) as below.
KB Fixing Plate
CONTROL HEAD | φ 6.5 | |
SIDE VIEW | ||
Tapping | ||
| ||
| Screw | |
KB Fixing | M5X25 | |
Plate | ||
CONTROL HEAD TOP VIEW | Upset | |
| Screw |
Tuning compartment (Performance Monitor SW inside)
Figure 1-16 How to attach KB fixing plate
11.Set dust cover KB (supplied) on the control head.
Attachment of hood
1.Set two spacers (supplied) to the lower two of the four M5 holes in the CRT panel.
2.Screw two screws (supplied) into the holes in the hood.
3.Set the bottom of the hood to the screws at the bottom of the CRT panel, and then fasten the two screws at the top of the hood to the CRT panel.
