Furuno FR-2135S manual Leading in cables to the display unit

Leading in cables to the display unit

The cable clamp may be positioned inside the display unit (default arrangement), outside the display unit or at the bottom of the display unit (when using console mount). When the cable clamp is located outside or beneath the display unit, use the bottom clamp front plate and bottom clamp rear plate (supplied with installa- tion materials).

Also, use the shielding foam (supplied) to protect against noise radiation.

Cable fed from back of display unit (default method)

Nav equipment		Slave display
(Gyrocompass)
Keyboard
Log		Navigation
	PWR	SCAN
		External CRT

Cable position in clamp (Display unit, rear view)

Nonslip rubber

If speed log and navigator are not connected, paste the nonslip rubber to the clamp and secure cables.

	Panhead screw
Hex bolt	M4X8
M5X12 SUS
2 pcs	(D) Rear clamp
	plate
Hex bolt	(C) Signal clamp
M5X35 SUS	(Aluminum)
2 pcs
Hex bolt
M5X35 SUS	(B) Power clamp
2 pcs
	(Aluminum)
	(A) Rear clamp
(Construction of	base
cable clamp)

(D) Rear clamp plate
	Make sure shielding foam contacts rear chassis.
(C) Signal cable	Rear cable entrance
(Aluminum)
(B) Power clamp
(Aluminum)
	Cable
(A) Rear clamp base	Shielding foam

(Display unit, right-hand side view)

(Display unit, rear view)

Figure 2-2 Default cable clamp position

•Place shielding foam between cables, and then attach the foam to aluminum clamps.

•Fill unused clamp holes with shielding foam.

2-2