Connection of external power supply
An external power supply is necessary when the repeater signal is
1.Cut jumper wire JP1 on the GYRO CONVERTER Board when an external power supply is used.
2.Connect gyro cable and power cable as shown below.
External Power Supply 20 - 135 VAC
20100 VDC
Gyrocompass (Step type)
A64P1106
J5
1 R2
2 R1/COM
Either connection in case of DC polarity.
S1 | J4 | |
1 S1 | ||
S2 | ||
2 S2 | ||
| ||
S3 | 3 S3 | |
COM | ||
4 T | ||
F.G. | ||
5 F.G. | ||
|
Figure 4-3 Connection of external power supply to GYRO CONVERTER Board
DIP switch, jumper wire settings
Default setting
The default setting of all DIP switches is off and all jumpers wire are set to “#1.” (Note that jumper wire JP1 is set at #1, #2, and #3.) In those settings the gyrocom- pass having the following characteristics can be directly connected; modification of the GYRO CONVERTER Board is not necessary.
AC synchronous signal: 50/60 Hz
Rotor voltage: 60 V to 135 V AC
Stator voltage: 60 V to 135 V AC
Gear ratio: 360x
Supply voltage: 30 V to 135 V AC
If the specifications of the gyrocompass differ from those mentioned above, change jumper wire and DIP switches settings on the GYRO CONVERTER Board. Set- tings may be changed according to gyrocompass specifications or make and model of gyrocompass (see page
