Display pedestal
Display pedstal front panel
Pan Head 
Screw M2.6X5
(2 pcs.)M-card case lid
Figure 4-13 Display pedestal, front view
5.Loosen six screws to remove the front panel on the display pedestal.
6.Set the RP Board (14P0298) in the top slot of the pcb card case.
7.Run the connector from the card case in front of the GYRO CONVERTER Board.
8.Plug the connector in J1 on the RP Board.
9.Fasten the ground wire from the connector at the location shown below.
RP connector
INT Board | GYRO | |
CONVERTER | ||
| ||
| Board |
FRONT
Fasten ground wire from connector to this screw.
(TOP VIEW)
RP Board
ARP Board
SPU Board
J1
Route cable between ARP and SPU Boards.
(FRONT VIEW)
