Furuno FS-5070 manual Scanning, Stopping timer operation, 10-9

10. NBDP TRANSMITTING, RECEIVING

When the predetermined time comes, the NBDP Terminal Unit automatically sends or receives the message. The results of timer operation are displayed as either OK or NG (No Good) on the Timer Operation List.

Timer Operation List

*1	OK
2
*3	OK
*OP4	OK
*OP5	NG

Timer operation list

10.6.2Stopping timer operation

1.Press the function key F3.

2.Press the 7 key.

3.Choose the operation (name) which has an asterisk attached to it and then press the Enter key. Remove all asterisks to cancel all timer programs.

10.7Scanning

The radio equipment scans a group of operator-selected frequencies (channels), and stops scanning when an signal is received. For registering scan group, see paragraph 8.5.

1.Press the function key F3 and then the 5 key to show the Scanning Group List on your screen.

You can confirm the scan channel by pressing the ↑ or ↓ key while pressing the Shift key.

Scanning Group List

1

2

3

Scanning group list

2.Choose a scan group and press the Enter key.

3.The scanning starts and the indication “Scan” appears in reverse video. Further, the name of the scan group appears in the Station Name field.

1:File 2:Edit 3:Operate 4:Window 5:Station 6:System 7:WRU 8:HR 9:Over 10:Break

				2002-09-08 2:01:46 UTC			Caps-Eng
Station Name	:	SAITO-1
					Scan	HT
Frequency (T/R) :		8344.00	/ 8705.00(kHz)	Comm Mode : Auto
Comm Status	:	Connect Send Lock Error
Sending Volume	:	100(%)	ARQ Error : 0	ARQ Time : 0(sec)

Communication status display

4.To stop scanning, press the function key F3 and then the 5 key. “Scan” disappears on the communication status display.

10-9