Furuno FS-5070 manual Geographical Area Call, Receiving message by Nbdp Terminal Unit

Change COM Frequency

Agree Disagree Count down xx sec. Pause

5. ROUTINE MESSAGE CALLING, RECEVING

Choose "Pause".	Change COM Frequency
	Agree	Disagree

Count down has been paused.

After 10 seconds passed or when "Agree" is chosen, the working frequency is changed with the message shown below.

Choose "Agree".

Accept New Working Freq

CANCEL: CLOSE WINDOW

Receiving message by NBDP Terminal Unit

After receiving a group call, confirm the following.

•The control unit’s display shows “OCCUPIED” and the Tx and Rx frequencies. •The message from the sending station appears on your NBDP Terminal Unit.

5.3Geographical Area Call

The geographical area call is for sending a call to all ships within the area you designate in your geographical area call. In the figure below, for example, the call will be sent to all ships within 24-34°N, 135-140°W (QUAD) and 34°N, 140°W, range: 500 NM (CIRCLE).

Note: At the high-latitude area, set the area so that the longitude is within 99°. If the setting is over 99°, it may be adjusted automatically.

Reference point (For example,

34°N 140°W)

34°N

10°

500NM

140°W

Reference point (For example,

34°N 140°W)

24°N

5° 135°W

QUAD CIRCLE

5-15