Furuno FS-5070 manual Receiving an individual call, No response! Try calling again?

5. ROUTINE MESSAGE CALLING, RECEVING

No response! Try calling again?

Re-send call: Push the ENTER knob followed by pressing the CALL key.

Cancel call: Press the CANCEL key to go to DSC screen.

5.1.2Receiving an individual call

Acknowledgement is able or unable depending on the comply-type setting (see section 6.11). The relationship between comply type and able/unable acknowledge is as shown in the table below.

Setting for ACK/SQ key		ABLE	UNABLE
AUTO ACK	Can send ABLE acknowledge		Can send UNABLE
	automatically		acknowledge automatically.
MANUAL ACK	Send	ABLE acknowledge	Send UNABLE acknowledge
	manually		manually

Note: The handset must be on hook to enable automatic acknowledge.

Sending automatic acknowledge (ACK BQ) with comply type “ABLE”

When an individual call is received and the automatic acknowledge feature is active (AUTO ACK) and the comply type is “ABLE,” the display shown below appears. This display indicates that the auto acknowledge (ACK BQ) call is being sent.

Able acknowledge message in progress!

DESTINATION ID:		123456789
PRIORITY	:	ROUTINE
TELEPHONE		2138.0 kHz
DSC FREQ :		2177.0 kHz
TIME TO GO:		6S

It takes about seven seconds to transmit the call, after which the audio alarm sounds and the following message appears.

Able acknowledge message transmitted.

CANCEL: STOP ALARM

PRIORITY: ROUTINE TX: 2138.0 kHz

TELEPHONE RX: 2138.0 kHz

1. Press the CANCEL key to silence the alarm. The following display appears.

5-7