Furuno FS-5070 manual Scan Channel Groups, Editing/Deleting user channels, Scan entry screen

8. NBDP PREPARATIONS

8.4.2Editing/Deleting user channels

1.Press function key F5 and then the 4 key.

2.Press the ↑ or ↓ key to choose channel from the Channel List.

3.Press ↓ and → keys to choose Change and press the Enter key.

4.Do one of the following:

Edit channel: Use ↑, ↓ and the Backspace key to make modifications.

Delete channel: Erase channel number with the Backspace key.

5.Press the Enter key twice.

6.Press the Esc key.

8.5Scan Channel Groups

You may store up to 10 scan groups, 20 channels per group. Note that scanning is only possible in the ARQ and FEC modes.

The NBDP Terminal Unit can control radio equipment through channel scanning. In FEC mode, the radio equipment scans a number of channels (according to your selection), stopping when an incoming signal is found. In the ARQ mode it stops when your own ID code is detected in an incoming signal. Also, in the ARQ mode, the transmitter is then tuned to the corresponding transmitter frequency, the communication link is established and the traffic is automatically exchanged. Scanning resumes once the link is disconnected.

8.5.1Registering scan channel groups

You may register ITU and user scan channels as follows:

1. Press the function key F5 followed by the 3 key to display the Scan Entry screen.

Scan Entry

Scanning Group List

Create

Change

					Scanning Set Up
	Group Name		:	_
	Ch Dwell Time		: 4.5 sec (2.7-4.5 sec)
	Mode		: AUTO ARQ FEC
	Auto Search		: OFF ON
	No	Channel		Rx Freq		Tx Freq	Pass/Scan
0							Pass/Scan
1							Pass/Scan
2							Pass/Scan
3							Pass/Scan
4							Pass/Scan
▼ 5

Scan entry screen

2.If Create is not underlined, press →, ↓ and the Enter key to underline it.

3.Group Name is selected. Enter suitable group name. (10 group names may be entered. If you attempt to enter more the message “Scan group memory is full. Press any key to escape.” Appears. Press any key and then delete unnecessary group names to enter

8-7