Furuno FS-5070 manual Intercom, Automatic setting of working frequency

1. OPERATIONAL OVERVIEW

•The other control unit in two controls unit system goes ON HOOK.

•NBDP stops scanning or communicating.

1.9.4Automatic setting of working frequency

The radiotelephone automatically sets working frequency in the following conditions:

•ABLE ACK is sent in response to individual call.

•Your ship receives ABLE ACK in response to own ship-initiated individual call.

•*Your ship receives ABLE ACK with COM. Frequency automatically changes in response to own ship-initiated individual call.

•Your ship sends geographical area call.

•Your ship sends distress relay.

•Your ship sends distress alert.

•*Your ship receives group call.

•*Your ship receives geographic area call.

•*Your ship receives distress alert.

*: When receiving a call with different frequency from the setting, the following window appears.

Change COM Frequency

Agree Disagree Count down xx sec. Pause

Choose "Pause".	Change COM Frequency
	Agree	Disagree

Count down has been paused.

After 10 seconds passed or when "Agree" is chosen, the working frequency is changed with the message shown below.

Choose "Agree".

Accept New Working Freq

CANCEL: CLOSE WINDOW

1.10Intercom

The built-in intercom permits voice communications between two control units.

1.Off hook the handset at the radiotelephone screen.

2.Press the IntCom key to show INTERCOM on the display. The called party’s control unit rings.

3.When the called party picks up their handset, start communications.

4.Hang up the handset to turn the intercom off. The indication INTERCOM disappears from the screen.

1-6