Furuno FS-5070 manual Turning the Power On/Off, Radiotelephone RT Screen, Radiotelephone RT screen

1. OPERATIONAL OVERVIEW

7/	key	Turns loudspeaker on/off.
		(Note that this key does not silence the distress or urgency alarm.)
8/PRINT key		Prints communications log files, current screen (except DSC standby
		screen and radiotelephone screen) and test results.
9/	key	Adjusts panel dimmer and LCD contrast.
*/FILE/CURSOR		•	Opens the send message file list from the DSC standby screen, to send
key			stored message.
		•	Shifts cursor.
0/LOG/TUNE key		•	Long press: Tunes antenna in radiotelephone operation.
		•	Momentary press: Displays message logs.
#/SETUP key		Opens the main menu.
ALARM lamp		•	Flashes in red for distress and urgency messages.
		•	Flashes in green for safety and routine messages.
OVEN lamp		Lights (in green) when mains switchboard is on.

1.2Turning the Power On/Off

Turn the PWR/VOL knob clockwise at the right-hand side of the control unit to power the system. The RT screen appears.

Rotate the PWR/VOL knob counterclockwise to turn the system off.

In the dual control unit system, the control unit connected to the CONTROLLER 1 port on the transceiver unit has priority and it controls the power for both the No.1 and No. 2 control units. The power switch of the No. 2 control unit powers on/off the No. 2 control unit only.

Note: Turn on power at switchboard more than five minutes before turning on this equipment.

1.3Radiotelephone (RT) Screen

Turn the power on, or press the 1/ RT/CH key to show the radiotelephone screen. This is where you set up the transceiver unit, and communicate by voice or telex.

CH: 200 DR

Tx: 2182.0 kHz

Rx: 2182.00 kHz

SSB SIMP HIGH FAST NB SQ

SEN	S
IA	10.0A
MMSI xxxxxxxxx		UTC 00:00
POS 35 00.0000N
135 00.0000E		EPFS 23:59

Radiotelephone (RT) screen

1-2