Furuno NX-700B manual Installation, 4.1Display Unit, Tabletop, overhead mounting

4.INSTALLATION

4.1Display Unit

The display unit can be installed on a tabletop, on the overhead, or in a panel. Refer to the outline drawings at the back of this manual for installation instructions. When selecting a mounting location, keep in mind the following points.

•Locate the unit away from exhaust pipes and vents.

•Locate it of direct sunlight, (or in a suitable, ventilated enclosure) to prevent heat which can build up inside the cabinet.

•The mounting location should be well ventilated.

•Mount the unit where shock and vibration are minimal.

•Allow sufficient maintenance space at the sides and rear of the unit and leave sufficient slack in cables, to facilitate maintenance and servicing.

•Compass safe distances are:

NX-700A (Standard: 1.45 m, Steering: 0.95 m)

NX-700B (Standard: 0.30 m, Steering: 0.30 m)

Tabletop, overhead mounting

1.Fix the hanger by using four self-tapping screws (5x20).

2.Screw knob bolts in display unit, set it to the hanger, and tighten the knob bolts.

Note: For the overhead mounting, reinforce the mounting location for the weight of the display unit (NX-700A: 3.3 kg, NX-700B: 0.7 kg) and secure the hanger, with bolts, nuts and washers (local supply).

NX-700A NX-700B

4-1