4. INSTALLATION

4.6Setting of Printer

After the connection completely, the setting of printer should be done for NX-700B as shown below. (For NX-700A, use the default setting as is.)

1.Press the key to turn the power on.

2.Press the MENU key to show the main menu.

Menu

NAVTEX

System

Display

Service

3.Press ▼ to choose System, and then press the ENT key or ► to activate the System menu.

System

Warn Msg Alm

Off

 

Signal Monitor

Off

Key Beep

Off

Time Offset

+00:00

 

Units

nm, kt

Printer

NX-700A

4.Press ▼ to choose Printer, and then press the ENT key or ► to show the item window.

None

NX-700A

Upright

Inverted

5.Press ▲ or ▼ to choose the appropriate setting, and then press the ENT key.

None: When no printer is connected.

NX-700A: For NX-700A only.

Upright: When NX-700B is connected to an upright-type printer which ejects paper in bottom to top direction.

Inverted: When NX-700B is connected to a bulkhead mount printer which ejects paper in top to bottom direction.

6.Press the MENU key several times to close the menu.

4-10

Page 56
Image 56
Furuno NX-700B manual Setting of Printer, System, None, Upright Inverted