268
Chapter 16: Troubleshooting
www.gateway.com

To free IRQ resources for the new device:

1In the Device Manager window, check the device list for a resource
conflict. A resource conflict appears as a black exclamation point
in a yellow circle.
2Remove the device you are trying to install, then determine which
one of the existing devices or ports you can disable.
3Right-click the device or port you want to disable, then click
Disable. The device or port is disabled.
Diskette drive
The diskette drive is not recognized
Shut down and restart your computer.
You receive a “Access Denied” or “Write protect” error message
Move the write-protection tab in the upper-right corner of the diskette
down (unprotected).
The diskette may be full. Delete unnecessary files on the diskette and try
again.
Not all diskettes are IBM-compatible. make sure that the diskette you are
using is IBM-compatible.
Try a different diskette. Occasionally diskettes are flawed and cannot be
read by the diskette drive.
You receive a “Disk is full” error message
Delete unnecessary files on the diskette.
Try a different diskette. Occasionally diskettes are flawed and cannot be
read by the diskette drive.
Run Error checking on the diskette. For more information, see “Checking
the hard drive for errors” on page 231. If errors are detected and corrected,
try using the diskette again.
You receive a “Non-system disk” or “Disk error” error message
Eject the diskette from the diskette drive, then press ENTER.
Make sure that the diskette you are using is IBM-compatible.