-42- g0651/g0652 10" extreme series table saws
2. pull an end cap off of the standard fence,
then remove four hex nuts, flat washers, t-
bolts and one side of the fence facing from
the fence body.
3. place the auxilliary fence next to the open
side of the fence and mark the location of four
mounting holes on the auxilliary fence.
4. pre-drill and countersink four mounting holes
on the auxilliary fence.
5. thread the flat head screws through the
auxiliary fence and into the hex nuts in the
standard fence body, and tighten securely, as
shown in figure 54.
figure 54. auxiliary fence.
;ZcXZ
;VX^c\
;ZcXZ
7dYn
6jm^a^Vgn
;ZcXZ
Resawing Operations
the table saw motor is pushed to its limits when
resawing. if the motor starts to bog down, slow
down your feed rate. motor overloading and blade
wear can be reduced by using a ripping blade.
ripping blades are designed to clear the sawdust
quickly.
components Needed for Resawing:
zero Clearance insert .........................................1
ripping Blade 10" ...............................................1
Clamps ...............................................................2
shop made auxiliary Fence ...............................1
shop made resaw Barrier .................................1
you may experience kickback during this
procedure. S tand to the side of the blade
and wear a full face shield to prevent injury
when resawing.
To perform resawing operations:
1. disConneCt the saW From poWer!
2. remove the standard table insert and the
blade guard/splitter, and install the riving
knife. install a ripping blade and the optional
model t20645 zero clearance table insert.
then lower the blade below the table sur-
face.
3. attach the auxiliary fence to the standard
fence and set it to the desired width.
Note: Account for blade kerf, the rough cut
made by the blade, and the inaccuracy of
the fence scale when the auxiliary fence is
installed when figuring out the correct width.
4. place the workpiece against the auxillary
fence and slide the resaw barrier against
the workpiece, as shown in figure 55. now
clamp the resaw barrier to the top of the table
saw at both ends.
6jm^a^Vgn
;ZcXZ
;ZcXZ
GZhVl
7Vgg^Zg
Ldg`e^ZXZ
;gdciK^Zl
figure 55. ideal resaw workpiece setup.