Workpiece

Inspection

Some workpieces are not safe to cut or may require modification before they are safe to cut.

Before cutting, inspecting all workpieces for the following:

Material Type: This machine is intended for cutting natural and man-made wood prod- ucts, laminate covered wood products, and some plastics. Cutting drywall or cementi- tious backer board creates extremely fine dust and may reduce the life of the bearings. This machine is NOT designed to cut metal, glass, stone, tile, etc.; cutting these materials with a table saw may lead to injury.

Foreign Objects: Nails, staples, dirt, rocks and other foreign objects are often embed- ded in wood. While cutting, these objects can become dislodged and hit the operator, cause kickback, or break the blade, which might then fly apart. Always visually inspect your workpiece for these items. If they can't be removed, DO NOT cut the workpiece.

Large/Loose Knots: Loose knots can become dislodged during the cutting opera- tion. Large knots can cause kickback and machine damage. Choose workpieces that do not have large/loose knots or plan ahead to avoid cutting through them.

Wet or "Green" Stock: Cutting wood with a moisture content over 20% causes unneces- sary wear on the blades, increases the risk of kickback, and yields poor results.

Excessive Warping: Workpieces with exces- sive cupping, bowing, or twisting are danger- ous to cut because they are unstable and often unpredictable when being cut. DO NOT use workpieces with these characteristics!

Minor Warping: Workpieces with slight cup- ping can be safely supported if the cupped side is facing the table or the fence. On the contrary, a workpiece supported on the bowed side will rock during a cut and could cause kickback or severe injury.

G0651/G0652 10" Extreme Series Table Saws

Non-Through &

Through Cuts

Non-Through Cuts

A non-through cut is a sawing operation where the blade does not protrude above the top face of the wood stock. Since non-through cuts require the removal of the blade guard and splitter, the riving knife must be installed. Dado cuts, rabbet cuts, and resawing operations are non-through cuts that can be performed with this table saw.

Non-through cuts have a higher risk of injury from kickback because the splitter and blade guard must be removed. Kickback is an event in which the workpiece is propelled back towards the operator at a high rate of speed. Always remem- ber to re-install the blade guard and splitter after performing a non-through cut.

Non-through cuts have a risk of kickback. Read, understand, and follow instructions and safety precautions for each type of cut to reduce the risk of injury.

Through Cuts

A through cut is a sawing operation in which the workpiece is completely sawn through. Ripping, crosscutting, miter cuts, and angled cuts are all through cutting operations. The blade guard and splitter or riving knife must be installed during through cuts.

Through cuts have a risk of kickback. Read, understand, and follow instructions and safety precautions for each type of cut to reduce the risk of injury.

Safety precautions and instructions for each type of cut are located on the following pages:

Ripping: Page 34

Crosscutting: Page 35

Miter Cuts: Page 35

Blade Tilt & Bevel Cuts: Page 36

Dado Cutting: Page 36

Rabbet Cutting: Page 38

Resawing: Page 40

-33-

Page 35
Image 35
Grizzly G0652, G0651 owner manual Workpiece Inspection, Non-Through Through Cuts, Non-Through Cuts