Grizzly G0651, G0652 owner manual Installing New Belt

Installing New Belt

1.Turn the flat belt sideways and slip it over the motor pulley, so it engages one or two grooves (Figure 67).

Flat Belt

Motor Pulley

Figure 67. Installing flat belt (table removed for

clarity.)

2.Push the belt inward and roll it onto the top pulley. Continue pushing the belt and rotating it up and down (Figure 68) until it is centered on both pulleys.

Flat Belt

Figure 68. Flat belt installed (table removed for

clarity.)

3.Lower the motor all the way down.

4.Loosen the motor mounting hex nuts two turns, then place the wood block on top of the motor.

-50-

5.Raise the motor to tension the belt, ensuring that the wood block is between the motor and cabinet, as shown in Figure 69.

Note: Be careful not to damage the motor, and do not force it up further when it becomes difficult to move the handwheel.

Wood

Block

Figure 69. Using wood block to tension belt.

6.Check belt deflection, as shown in Figure 70. Adjust deflection by raising or lowering the motor until you can deflect the belt no more than 1⁄8".

EjaaZn

9Z[aZXi^dc

EjaaZn

Figure 70. Checking belt deflection.

7.Tighten the motor mounting hex nuts, lower the motor, and remove the wood block.

8.Close the motor cover.

G0651/G0652 10" Extreme Series Table Saws