INTRODUCTION
Foreword
We are proud to offer the Model G0651/G0652 10" Extreme Series Table Saw. This machine is part of a growing Grizzly family of fine wood- working machinery. When used according to the guidelines set forth in this manual, you can expect years of
The specifications, drawings, and photographs illustrated in this manual represent the Model G0651/G0652 when the manual was prepared. However, owing to Grizzly’s policy of continuous improvement, changes may be made at any time with no obligation on the part of Grizzly. For your convenience, we always keep current Grizzly manuals available on our website at www. grizzly.com. Any updates to your machine will be reflected in these manuals as soon as they are complete. Visit our site often to check for the latest updates to this manual!
Contact Info
We stand behind our machines. If you have any service questions or parts requests, please call or write us at the location listed below.
Grizzly Industrial, Inc.
1203 Lycoming Mall Circle
Muncy, PA 17756
Phone: (570)
Fax: (800)
Web Site: http://www.grizzly.com
If you have any comments regarding this manual, please write to us at the address below:
Grizzly Industrial, Inc.
C/O Technical Documentation Manager
P.O. Box 2069
Bellingham, WA
Functional Overview
A table saw is considered the primary machine in any woodworking shop and is capable of the following cuts:
•Rip and Crosscuts
•Miters, Bevels, Compound Miters
•Rabbets and Dadoes
•Tenons and Mortises
•Resaw Cuts
The main components of a table saw are the cabinet, table top, extension tables, main blade and arbor, rip fence, miter gauge, blade guard and splitter, and riving knife.
A typical rip cut using the table saw is made by adjusting the fence to the desired width of cut, set- ting the blade height and tilt with the handwheels, and placing the workpiece on the table against the fence so the waste portion of the workpiece is on the opposite side of the blade. Featherboards can be installed on the fence or clamped to an auxillary fence to control thin or narrow stock.
The operator turns the table saw ON, and while standing slightly to the side of the blade, uses a push stick to guide the workpiece through the blade. The saw blade teeth cut a kerf in the workpiece, which is held open by the splitter or riving knife, helping reduce the risk of kickback. The operator pushes the workpiece past the blade, turns the saw OFF, and waits until the blade has come to a complete stop before remov- ing the workpiece.
A typical crosscut is performed in a similar man- ner, except the fence is removed and the miter guage is used to push the workpiece through the blade.
To produce accurate results, the miter slot and rip fence must be adjusted parallel to the blade. The type of cut to be performed typically determines the type of blade that will be used.
G0651/G0652 10" Extreme Series Table Saws
