Grizzly G0652, G0651 owner manual Assembly, To assemble the extension table and outfeed tables

Assembly

To assemble the extension table and outfeed tables:

1.Fasten the 911/2" front rail onto the table saw with four M8-1.25 x 25 flat head screws, as shown in Figure 11. Also, secure the far left side of the rail with an M8-1.25 x 25 flat head screw, lock washer and hex nut.

x 4

Figure 11. Front rail installed.

2.Fasten the 79" rear rail to the table with four M8-1.25 x 25 cap screws, lock washers, and flat washers, as shown in Figure 12. Secure the left side of the rail to the table with an M8-1.25 x 25 cap screw, two flat washers, two lock washers, and a hex nut.

x 4

Figure 12. Rear rail installed.

G0651/G0652 10" Extreme Series Table Saws

3.Secure the metal plates to the table with M8-1.25 x 25 flat head screws on the right side of the table saw cabinet, as shown in (Figure 13), then thread two M8-1.25 x 12 hex bolts with flat washers into the metal plates. Do not fully tighten the bolts.

x 2 Metal Plate

x 2

Figure 13. Metal plates installed.

4.With the help of an assistant, place the exten- sion table between the rails and slide the table slots over the hex bolts installed in Step 3.

5.While an assistant holds the extension table, fasten the 911/2" front rail to the extension table with three M8-1.25 x 25 flat head screws, flat washers, lock washers, and hex nuts (Figure 14). Finger-tighten for now.

x 3

Figure 14. Front rail/table fastener locations.

-21-