Hasselblad 3034216 user manual All Hasselblad EL models

Adapter EL

All Hasselblad EL models

Exposure Cable EL

All Hasselblad EL models except ELD

•The Exposure Cable EL (supplied) should be connected.

•Only the single shot function (A or AS mode camera settings) should be set on the camera. Rapid sequence shots are not possible.

•Use the Adapter EL (supplied) to provide the necesssary extension beyond the motor hous- ing of the EL models for battery attachment. It is attached to the CFV in the same manner as a battery, and the battery itself is then attached to the adapter as in the illustration.

ELX

For use with 500EL/ELM and 500/553ELX models:

•Make an ELX setting.

•The Exposure Cable EL (supplied) should be connected.

•All exposures times, including the B setting, function correctly without having to alter the “Exposure Time” setting.

•Rapid sequence shots are not possible.

•Use the Adapter EL (supplied) to provide the necesssary extension beyond the motor hous- ing of the EL models for battery attachment. It is attached to the CFV in the same manner as a battery, and the battery itself is then attached to the adapter as in the illustration.

Pinhole

For use with lenses/cameras with no shutter. Intended primarily for use in a studio en- vironment where complete darkness can be achieved and exposures made accordingly (also useful for ‘light painting’). In this mode the CFV uses the exposure time (as well as other required stages in a capture sequence) set in the Capture Sequence dialog. The back can be triggered either via the START (MENU/EXIT) button or from FlexColor (see later section for full description of Capture Sequence settings procedure).

Flash sync

For use with non-modified 200 series models (together with C-lenses in C-mode), an ArcBody, a FlexBody or view cameras with a Hasselblad adapter.

•Make a Flash sync setting.

•The Flash sync input cable (supplied) should be connected to the Flash sync in terminal.

•All exposures times, including the B setting, function correctly without having to alter the “Exposure Time” setting.

•Do not use a winder at rapid sequence setting.

SWC

For use with 903 SWC and 905 SWC models.

• Make an SWC setting.

PLEASE NOTE: Due to the mechanical design of the SWC, pressing the exposure release button too slowly may cause a faulty capture with a magenta cast. Either press the button much more distinctly or alternatively change the setting from SWC to Flash sync and use the flash sync cable to connect the lens to the CFV.

200

For use with modified 202, 203 and 205 models together with F-lenses or CF-lenses in F-mode. (Only these three models can be modified for cable-free compatibility with the CFV. Please contact your Hasselblad dealer for further information)

•Make a 200 setting.

•A Flash sync input cable should not be used.

•All exposures times, including the B setting, function correctly without having to alter the “Exposure Time” setting.

•Do not use a winder at rapid sequence setting.

48