2 SCREWS
Figure 9.7 To attach the first section of vent pipe, make sure to use the fiberglass gasket to seal between the first vent component and the outer fireplace wrap. Use 2 self tapping screws to secure the gasket to the outer wrap.
Note: Once the seal cap has been removed, it cannot be reattached.
B. Rear Vent
NOTICE: Once appliance is set up for top or rear venting, it CANNOT be changed at a later time.
Figure 9.8 Fold the tabs toward the center of the fire plug (90º) and remove the insulation gasket.
NOTICE: Once the seal cap has been removed it CANNOT be reattached.
Figure 9.10 Fold the center parts of the retaining band out and use to remove the seal cap.
Figure 9.11 Discard the seal cap, remove and discard the insulation basket. Note: Once the seal cap has been removed it CANNOT be reattached.
Figure 9.9 Cut the metal retaining band and fold the sides out.
Figure 9.12 Attach the first vent section (it will snap into place). Slide the insulation gasket onto the vent section, up against the appliance and over the tabs. Use two self- tapping screws to secure gasket to outer wrap.
42 | Heat & Glo • |
|
