4.Remove screws from each end of burner assembly. Pull burner out of appliance. Set aside.
SIDE BURNER SCREW
Figure 12.11. Side Burner Screw.
5.Remove left or right side glass pane frame, depending on placement of blower, from bottom of firebox. Remove glass pane and gaskets. Gaskets may have become fragile from heat exposure. Handle with care. At this point, blower and other components located under the firebox are accessible.
Figure 12.12. Glass Pane Frame.
Figure 12.13. Removing Glass Pane Frame.
6.Locate the fan mount fastener on either the left or right side of the appliance. See Figure 12.14. Remove fastener.
FAN MOUNT FASTENER
Figure 12.14. Fan Mount Fastener Location.
7.Slide fan forward slightly to release it from the fan mount housing.
8.Locate blower power wires and unplug them from their locations. Note these positions for reinstallation.
9.Remove blower from appliance. See Figure 12.15.
Figure 12.15. Remove Blower from Appliance.
10.Remove mounting plate from blower by removing the four screws that hold the blower to the plate. Save the gasket for use with the new blower. See Figure 12.16 and Figure 12.17.
Figure 12.16. Remove Mounting Plate
50 | Heat & Glo • RED40, RED40ST • |
